ATEM switchers
Drive a Blackmagic ATEM switcher from the Stream screen, with its multiview and its panel, and stream from the ATEM or from this computer.
Connect
- Connect the ATEM to the same network as this computer. Its IP address is in ATEM Setup.
- In Settings → Stream → Switcher, set Switch with to ATEM, enter the Address and press Connect. Switcher then shows the model and firmware.
- Under Multiview, choose the capture device carrying the ATEM’s multiview.
Any ATEM on firmware 7.2 or later. The panel shows the keys, downstream keys, macros, recording and audio the switcher has. With no multiview picture, its inputs show as tiles. Connect and Disconnect are also at the top of the Stream screen.
The panel
- Click a window of the multiview to put that input on Preview; double-click it to cut it to air.
- The Program and Preview rows, CUT, AUTO and the fader bar work as on the switcher.
- MIX, DIP, WIPE, DVE and STING choose the transition. Rate sets its length in frames.
- Next transition: BKGD and KEY 1, KEY 2… choose what the next transition takes. ON AIR 1, ON AIR 2… put a key on or off air at once.
- Downstream keys: TIE, ON AIR and AUTO for each DSK.
- FTB fades to black, and back.
- On the right: Recording on the switcher (Record and Stop recording), Macros (click one to run it), and Audio (On, AFV or Off for each input, and its level).
Streaming with an ATEM
Under Settings → Stream → Switcher → Sending, choose who sends the stream with Sent by. The stream key and service are set on the Stream tab either way.
- The ATEM: Go live sets the switcher’s streaming to your service and key, and starts it. Not offered for a switcher that cannot stream.
- This computer: under Program, choose the capture device that carries the ATEM’s program. Quality and Sound on the Stream tab apply only to this choice.