Getting started / Audio setup

Audio setup

Choose the input AutoSermon listens to, and set its level.

Choose the input

  1. Open Settings → Transcription → Microphone.
  2. Pick the input under Microphone. Default system microphone uses the computer’s default.
  3. If the list shows no names, press Test once and allow access.

Sound desk feed or room mic

A feed from the sound desk gives the cleanest speech: an aux send into a USB audio interface, or the desk’s own USB output. A room microphone also picks up the congregation, the speakers and the echo, and misses more words.

  • Include the pulpit and any reader or lectern mics, so references and readings are heard.
  • To follow songs, include the worship leader and choir mics. A send with the vocals above the band works better than the full mix.

Set the level

Set the level at the desk or the audio interface. AutoSermon has no gain control.

  1. On the Microphone tab, press Test.
  2. Have someone speak at preaching volume. The Input level bar should move with each phrase and fall back between them.
  3. If it barely moves, raise the send or the interface gain. If it stays near full, lower it: distorted audio loses words.
  4. Press Stop test.

Noise reduction and choirs

Noise reduction filters steady background noise but can cut held notes. It is off by default. Leave it off when there is singing, and always for choirs.

  • Settings → Transcription → Microphone → Noise reduction.
  • Or ··· in the Live transcription panel → Noise reduction.

What else affects accuracy

  • Recognition language, on the Transcription tab of Settings → Transcription. The default model, NVIDIA Nemotron + Parakeet, hears English only. For another language, install Small or Base; the page says which.
  • Speed. Check speed says whether Small or Base keeps up on this computer. A model that falls behind loses words.
  • Other programs. Streaming or video software running at the same time can slow transcription.
  • Sample rate. Match your audio interface; the default, 48 kHz, suits most USB interfaces.

If nothing is heard

  • A red banner in the Live transcription panel means microphone access was refused. Press Request access, or allow AutoSermon in the system’s privacy settings, then press Permissions.
  • On Windows, check that Settings → Privacy & security → Microphone lets desktop apps use the microphone.
  • If the microphone is unplugged or in use, the banner offers Choose microphone.
  • If the level bar moves in Test but no transcript appears, check Settings → Transcription for a model that is installed and selected.